Publicité
Les langues disponibles
Les langues disponibles
Dimensions
356
240
Installation
Installation must be carried by skilled, qualified technicians in accordance with current regualtions.
Preliminary checksN.B.
Before beginning to install, the following is necessary:
Set up a suitable omnipolar cut-off device, with distances greater than 3 mm between contacts, wit sectioned power source;
• Set up proper conduits and electric cable raceways, making sure these are protected from any mechanical damage;
• Set up a drainage tube to prevent moisture stagnation that may cause oxydation;
• Check that any connections inside the container (made for continuity purposes of the protective circuit) be fitted with extra insulation
compared to other internal conductive parts;
Tools and materials
Make sure you have all the tools and materials needed to carry out the installation in total safety and in accordance with current regula-
tions. The figure shows some examples of equipement used by installers
450
460
max. 6500
Publicité
