Tube Fittings, Push-In-Type (Secondary Metering Devices) - Lincoln Quicklub SSV 6 Instructions De Service

User Manual
Operating Instructions
Determining the Lubricant Output by Combining Outlets, continuation
Tube Fittings, Push-in Type (secondary metering devices)
Fig. 28 Instal l the push-in type outlets fittings and closure plugs in accordance with the dosage
1 - Inlet fitting
2 - Delivery borehole of the piston
Fig. 29 Single, double and triple lubricant output
... x - Outlet quantity (1x: single, 2x: double, etc.)
1 .. 10 - Outlet numbers
A - Clamping ring (brass)
Page 18 of 24
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Operation, continuation
3 - Closure plug installed in
outlet borehole with copper washer
4 - Closure plug (M11x1),
piston (chamfered)
5 - Valve body assembly
(with knurled collar)
Single lubricant output
- The simple lubricant out put is the lubricant quantity dis-
Double or multiple lubricant output
If one or more lubrication points require a double or a
multiple lubricant amount, this can be performed by clos-
ing one or more outlets.
As shown in fig. 29, outlet borehole 10 has been closed.
The lubricant quantity supplied by this outlet flows out of
the metering device via outlet 8.
Total quantity at outlet 8:
1014b 96
- is the quantity of outlet 8
- plus the lubricant quantity of outlet 10.
If a triple quantity is needed (at outlet 1), close the outlet
borehole located above the discharge borehole. Refer to
outlets 3 and 5 on fig. 29.
6 - Junction channels
7 - New closure plug with hex. socket head
and seali ng edge, outlet borehole,
replacement for pos. 3
pensed by a piston per stroke and per outlet borehole to
one lubrication point. It amounts to 0.2 cm³ on SSV
and 0.07 cm³ on SSV M.
2.2EN-20001-I11
12 04c95