Tube Fittings, Push-In-Type (Main Metering Device) - Lincoln Quicklub SSV 6 Instructions De Service

User Manual
Operating Instructions
Determining the Lubricant Output by Combining Outlets , continuation

Tube Fittings, Push-in-Type (main metering device)

Fig. 27 Instal l the push-in type outlet fittings and the closure plugs in accordance with the dosage
1 - Inlet fitting (optionally with protective
1)
cap )
2 - Delivery borehole of the piston
1)
on demand
NOTE
In the case of construction machines or
agricultural machines use high-pressure
hoses for the lubricant feed lines. In this
case, secondary metering devices (see
6001a 02
fig. 26) must also be equipped with check
valves with reinforced collet (standard
flange, see fig. 3).
NOTE
In the case of push-in type fit tings the
clamping ring is always a firm component
of the valve body 5.
6001a 02
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Operation, continuation
3 - Closure plug with copper
washer installed in outlet borehole
4 - Closure plug (M11x1),
piston, (chamfered)
5 - Valve body assembly
(with reinforced collar)
2.2EN-20001-I11
6 - Junction channels
7 - New closure plug with hex. socket head
and seali ng edge, outlet borehole
replacement for pos. 3
12 03c95
Page 17 of 24