Pressure Plastic Tubes And High-Pressure Hoses - Lincoln Quicklub SSV 6 Instructions De Service

User Manual
Operating Instructions

Pressure Plastic Tubes and High-pressure Hoses

Pressure plastic tubes Ø6 x 1.5 mm
Use the pressure plastic tubes only in the low-pressure
area, i. e. between secondary metering device and lubrica-
tion point.
High-pressure hose NW 4.1 x 2.3 mm
Fig. 7 Preassembly of threaded sleeves and hose studs on the
high-pressure hose
1 - Threaded sleeve
2 - High-pressure hose NW 4.1 x 2.3 mm
3 - Hose stud
Fig. 8 Preassembly of threaded sleeve by means of adjusting
gauge
1 - Threaded sleeve
2 - High-pressure hose NW 4.1 x 2.3 mm
3 - Adjusting gauge 432-23077-1
Page 8 of 24
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Installation, continuation
Use the high-pressure hose in the high-pressure area, i.e.
between the pump, main metering device and secondary
metering devices.
Adhere to t he pressures and bending radiuses mentioned
in the chapter "Technical Data" when installing the parts
and operating the device.
Install ing the threaded sleeves and hose studs on the
high-pressure hose
Screw threaded sleeve, item 1 Fig. 7, counterclockwise
onto high-pressure plastic hose 2 until illustrated dimen-
sion of 11 mm is reached. Then screw hose stud 3 into
threaded sleeve 1.
1028a9 6
1029a9 6
NOTE
Adhere to the pressures and bending radi-
uses mentioned in the chapter "Technical
Data" when installing the parts and operat-
ing the device.
6001a 02
IMPORTANT
Before screwing the parts 1, 2 (inside and
outside) and 3, rub them with oil.
NOTE
6001a 02
The outside diameter of the high-pressure
hose may show variations in dimension. In
such a case, press the threaded sleeve 1
at the end where it will be screwed onto
the high-pressure hose so that it becomes
oval in shape (1 to 2 mm). This will prevent
the high-pressure plastic hose from being
pushed out of the sleeve when the hose
stud is screwed.
NOTE
When using the special adjusting gauge
432-23007-1 (see Parts Catalog) screw
threaded sleeve counterclockwise onto
high-pressure plastic hose until the gauge
6001a 02
inserted in the sleeve begins to rise.
2.2EN-20001-I11