Battery Care; Charging Lights Sequence - Numatic CRO 8055 Notice Originale

Battery Care

!
UNDER NORMAL DAILY USAGE:
Re-charge the machine FULLY after each use regardless of machine operation time.
Do not leave the machine in a discharged state.
Charging Light Sequence
Signal (LED)
Red LED on
Orange LED on
Green LED on
Red LED flashing
followed by Pause
NOTE: Only available on certain models.
Under abnormal use;
i.e. leaving the machine without charging for a period of time, we advise that you follow these steps:
If the machine will be standing unused for a period of 30 days or more, then batteries
must be fully charged and battery fuses removed using the maxi fuse-puller provided,
prior to this period.
Batteries should be recharged every three months.
Charge fully the day before you start using the machine again.
30
www.numatic.co.uk
To ensure your machine remains at its maximum efficiency
and prolong your battery life, please follow the simple steps below:
First Phase (constant current Mode)
Second Phase (Constant Voltage Mode)
Third Phase (Constant Voltage Mode) Charge Complete
Cooling Fan Locked > 1 flash between pause
Over Voltage Protection / Output Short Circuit / Battery Reverse Polarity > 2 flashes between pause
Over Temperature Protection > 3 flashes between pause
Charge Time has exceeded 10 hrs during phase 1 or 2 > 4 flashes between pause
Meaning
!