Disassembly; Disposal - Abicor Binzel FEC 115 V Mode D'emploi

FEC

11 Disassembly

DANGER
Risk of injury due to unexpected start
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the FEC fume extraction system.
• Close off the compressed air supply.
• Disconnect all electrical connections.
CAUTION
• Check and wear your personal protective equipment.
• Personal protective equipment consists of protective clothing, safety goggles, a class P3 respiratory mask, protective
gloves and safety shoes.
• Personnel near the fume extraction system when it is being disassembled must wear personal protective equipment.
• It is not allowed to clean the fume extraction system using compressed air or a hammer.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Note the following instructions:
 10 Troubleshooting on page EN-24.

12 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctly
dispose of the product, it must first be disassembled.
12.1 Materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents may not contaminate the ground or enter the sewage system. These substances must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables' manufacturer.
The disposal of dust collecting bags is subject to special waste regulations. The dust must not enter sewage systems or be
disposed of together with normal household waste. Observe the local and official regulations.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0533.0 • 2019-11-15
11 Disassembly
EN - 25