Automatic Starting; Automatic Starting Functions En; Current Clamp (Optional) En - Abicor Binzel FEC 115 V Mode D'emploi

6 Commissioning
1 Connect the torch system (4), hose, and rubber connector to the fume extraction system (1).
2 Plug in the power plug.
3 Switch on the fume extraction system on the control panel with the I / Power button.
 Fig. 3 Control elements on page EN-10
NOTICE
• An external current clamp can be added on and is available as an accessory.
 6.3 Current clamp (optional) on page EN-13

6.2.1 Automatic starting

The automatic starting function allows the FEC to be automatically switched on when the welding process starts.Once the
welding process begins, the FEC receives a signal and automatically starts the fume extraction process.
1
6
1 Control panel
2 A / Auto button
Fig. 5 Automatic starting
1 Lay the ground cable (4) in the integrated automatic Start-Stop system (6).
2 Connect the ground cable (4) on one end to the power source and on the other end to the welding table, for example.
3 Press the A / Auto button (2) on the control panel (1).
 5.1 Control elements on page EN-10
The FEC starts automatically when the welding process is started.
EN - 12
3 Motor protective switch
4 Ground cable
2
3
4
5
5 Power cable connector
6 Integrated automatic Start-Stop system
BAL.0533.0 • 2019-11-15
FEC