Publicité
Les langues disponibles
Les langues disponibles
A SPEAKERS B
+
TEST
À
LEVEL
BALANCE
O00 |
ome QO ©
siete
Seal
CD
Sega]
OOOO ]
DOC
Cees)
s
SH
|
"SPEAKERS—
D
L—
C= R= RS—LS—SW
D
à
=
|
|
Preparatory steps
|
Do these steps to get the most from your home theater system.
Adjusting speaker output level
Adjust speaker level so the output from all the speakers is the
same apparent level when sitting where you would normally enjoy
a source.
1
2
6
Press [A] to turn on the SPEAKERS A.
You cannot adjust when SPEAKERS B is selected.
Press [TEST] to output the test dignel:
"TEST" appears on the display.
The signal is output from each speaker in order for about
two seconds each:
L: Front speaker (left)
C: Center speaker
R: Front speaker (right)
RS: Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
Speakers set as "NONE" or "OFF" are skipped.
DSP switches to SURROUND
mode when the test starts.
Press [VOL (- or +)] to set the volume
level normally used for enjoying the
source.
Use
[BALANCE]
if the
left right balance
of the
front
speakers is off.
Press [LEVEL] to select the speaker
channel to adjust.
The current level appears on the display.
Press again to change the speaker channel.
E Pre
Speakers set as "NONE" or "OFF" are skipped.
Press [-] or [+] to adjust the level to
the same apparent level as the front
speakers.
C, RS, and LS can be adjusted between —-10 dB and +10
dB, with zero being the current level of the front speakers.
SW can be adjusted between 1 and 25.
Repeat 4 and 5 for each speaker
channel.
To stop the test signal
Press [TEST].
The test signal will not be output if DSP DEFEAT
is engaged.
Ensure DSP is ON (# Page 19).
ROT5307
Publicité
