Wolf IR365PE/S/PH Guide D'utilisation Et D'entretien page 13

Oven Operation
Temperature Probe
Use only the temperature probe shipped with this appli-
ance. Refer to the illustration below. The temperature
probe measures the internal temperature of food while
cooking. The probe can be used to monitor the tempera-
ture without setting a desired temperature and can be used
with all cooking modes except Broil, Proof, and Dehydrate.
Setting controls:
Preheat the oven to the desired oven temperature in
1
the desired mode.
Completely insert the probe sensor into the thickest
2
area of the food.
3 When preheat is complete, place food in the oven.
Insert the probe into the probe receptacle. Refer to the
4
illustration below. Close the oven door.
Touch Probe.
5
6 Touch Set to select the preset temperature. To change
the temperature, use the slide bar to select the desired
temperature, then touch Set.
7 A chime indicates the temperature is 5°F
the set temperature. The oven chimes and the set
temperature flashes when the internal temperature
reaches the setpoint.
Remove, then reinsert the probe to verify the internal
8
temperature.
Touch the flashing temperature to clear.
9
Temperature probe
below
(1°C)
Probe receptacle
CAUTION
Pull straight down when removing the probe from
the receptacle. Bending or pulling the probe at an
angle during removal may damage the probe and
oven. Do not place a rack or accessory in rack posi-
tion six when using the probe, as it interferes with
probe removal.
CAUTION
The probe and probe receptacle will be very hot.
Handle with care.
wolfappliance.com | 13