Kärcher MC 250 Implements Mode D'emploi page 51

2.6.6 Cleaning the vehicle
The vehicle with the waste container can be cleaned with
a high-pressure cleaner.
● Clean critical areas such as bearings, tyres, etc. with re-
duced pressure and without a rotary nozzle.
● Do not clean areas with electrical components with the
high-pressure cleaner.
Figure: Cleaning the vehicle
2.7 Front power lift
● Front power lift 2.852-755.0
2.7.1 Intended use
This chapter describes the attachment and removal of a
front power lift on an MC 250.
Various different attachments can be attached to the front
power lift using a 3-point mounting.
The attachment kit may only be used as intended.
2.7.2 Installing the front power lift
Changing carriage 2.852-067.0
1
Front power lift
2
Front power lift mounting
3
Hydraulic hose couplings (2x)
4
1. We recommend using a changing carriage 2.852-067.0
when attaching to the vehicle.
2. When attaching the front power lift for the first time (ap-
prox. 110 kg), use a crane or similar to position it on the
changing carriage.
3. Stop the vehicle on level, solid ground and secure it
against rolling away.
4. Open the lock, see chapter "Opening/closing the lock".
Lift truck
1
Front power lift
2
Vehicle mounting frame
3
5. Position the changing carriage with front power lift with
the lift truck in the middle in front of the vehicle, then in-
sert it into the vehicle mounting frame as far as it will go.
6. The front power lift mountings must engage in the left
and right attachment points of the vehicle.
Vehicle attachment point
1
Front power lift
2
Lock
3
Lock screw and lock nut
4
7. Tighten the lock on both sides with screws and secure
with a lock nut.
a An open ring spanner is required to counter the nut
b See also chapter "Opening/closing the lock"
8. Lower and retract the lift truck.
Hydraulic connections
1
Front power lift
2
English 51