Publicité
Les langues disponibles
Les langues disponibles
2.3
2-brush sweeping system attachment (ex
works)
2.3.1 View of the device for a 2-brush sweeping
system
Figure: Sweeping system attached
2-brush sweeping system with suction mouth
1
Side brushes
2
Water connection
3
Hydraulic connection
4
Attachments power supply
5
2.3.2 Requirements for removal/installation
A changing carriage is required for removing/attaching the
sweeping system.
Note
Optional accessory, order no. 2.852-862.0
1 Park the vehicle on a level surface.
2 The brush system must be sitting on the changing car-
riage for removal/installation from/on the vehicle. Use a
lift truck for removal/installation.
3 The corresponding > Sweep < program must be select-
ed on the display.
2.3.3 Removing the 2-brush sweeping system
attachment
The removal of the sweeping system is described with the
optionally available changing carriage.
Figure: Sweeping system with changing carriage
Holder for hydraulic hose couplings on the changing
1
carriage
Lift truck
2
Hydraulic hose couplings on the vehicle
3
Side brush holder
4
Side brush
5
1. Stop the vehicle on level, solid ground and secure it
against rolling away.
2. Move the changing carriage into position under the ve-
hicle using the lift truck.
3. Move the side brushes individually into the side brush
holder and lower into the correct position.
4. Depressurise the front hydraulics. See chapter "Depres-
surising the hydraulic system".
5. Pull off the hydraulic hoses, water connections and pow-
er supply connection and store them in the holder on the
changing carriage.
6. Release the suction hose at the suction mouth (hose
clip).
7. Open the locks (left and right). See chapter "Opening/
closing the lock".
8. Extend the changing carriage with sweeping system
with suction mouth.
9. Raise and secure the waste container.
Lynch pin (lock)
1
Holder with suction hose
2
Water connections
3
10.Release the lock on the holder.
11.Release both water connections.
12.Pull out the holder with the attached suction hose up-
wards.
13.Store the sweeping system in a safe and dry place.
2.3.4 Attaching the 2-brush sweeping system
attachment
Attachment of the sweeping system is described using the
optionally available changing carriage. The corresponding
>Sweep< program must be selected on the display.
Carrier connection
1
Screw
2
Eyebolt
3
Lock-nut
4
English
39
Publicité
