Kärcher MC 250 Implements Mode D'emploi page 33

1 Ex-factory attachment
1.1 Waste container attachment
The waste container attachment can only be used in con-
junction with a Kärcher brush sweeping system or scrub-
bing system. These attachments are described after the
chapter.
1.1.1 Removing the waste container
The waste container can only be removed and set down
when the support attachment kit (optional) is used. The de-
scription assumes the use of the support attachment kit.
DANGER
Risk of injury from the waste container
Keep a sufficient distance from the waste container and
the supports when removing/installing.
Maintain a sufficient clearance to the hazard zone and stop
raising/lowering of the waste container immediately when
a person enters the hazard zone.
Secure the raised waste container with the safety supports
when you work underneath.
Only remove the waste container when it is completely
empty.
ATTENTION
Risk of injury and damage
Set the waste container down only on a level and smooth
surface.
1. Empty the waste container before removing the waste
container. See chapter "Emptying the waste container".
Figure: Waste container secured
Waste container
1
Safety support
2
Sealing collar
3
2. Raise the waste container until the safety supports can
be folded forward. See chapter "Emptying the waste
container".
3. Lower the waste container onto the safety supports.
Sealing collar
1
Hose clip
2
4. Remove the sealing collar by opening the hose clip (SW
7) and pulling off the sealing collar.
Figure: Variant A with 2 short locking pins
Front locking pin, short
1
Spring pin
2
Rear locking pin, short
3
Figure: Variant B with long locking pin
Locking pin, long
1
Spring pin
2
Hexagon bolt
3
5. Variant A: First pull out the spring pins and then pull out
the front short locking pins (left and right).
6. Variant B: First pull out the spring pins and then com-
pletely pull out the long locking pins (left and right).
a Use an impact extractor (slide hammer) for pulling out
b For this, unscrew the hexagon bolt and screw the
slide hammer into the existing thread.
English 33