Kärcher MC 250 Implements Mode D'emploi page 42

Adjusting the brush contact pressure
8. The brush system has a hydraulic brush contact pres-
sure relief system.
2.3.8 Storage
WARNING
Risk of injury and damage
Note the weight of the device.
ATTENTION
Risk of damage
Store the attachment kit in a protected, level and dry place.
Ensure that the sweeping brushes are not loaded.
1. Store the sweeping system that has been removed from
the vehicle on the changing carriage.
2. Ensure that the sweeping brushes are not loaded during
attachment to the vehicle.
2.4 3-brush sweeping system attachment (ex
works)
2.4.1 View of the device for a 3-brush sweeping
system
Front brush
1
Front brush arm
2
Side brushes (2-brush sweeping system)
3
Linear unit (carriage)
4
2.4.2 Requirements for removal/installation
A changing carriage is required for removing/attaching the
sweeping system.
Note
Optional accessory, order no. 2.852-862.0
1 Park the vehicle on a level surface.
2 The brush system must be sitting on the changing car-
riage for removal/installation from/on the vehicle. Use a
lift truck for removal/installation.
3 The corresponding > Sweep < program must be select-
ed on the display.
42
2.4.3 Removing the 3-brush sweeping system
Changing carriage 2.852-862.0
1
Short locking plate
2
Long locking plate
3
Retaining clip (2x)
4
1. Remove the 3-brush sweeping system with the option-
ally available changing carriage.
2. Stop the vehicle on level, solid ground and secure it
against rolling away.
3-brush sweeping system
1
Changing carriage
2
MC 250
3
Lift truck
4
3. Move the changing carriage into position under the ve-
hicle using the lift truck.
4. Move the side brushes individually into the side brush
holder and lower into the correct position.
Brush arm for front brush
1
Long locking plate
2
English