Kärcher MC 250 Implements Mode D'emploi page 56

Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2019/11/01
2.11 Central lubrication attachment (ex-factory)
The central lubrication attachment is part of the scope of
delivery when ordered ex-factory.
The central lubrication system is ready for operation on de-
livery and all settings (lubrication duration and interval) are
adapted and set to the delivered vehicle. Intervention by
the operator is not necessary.
The lubrication work according to the maintenance sched-
ule (see chapter "Care and maintenance of the vehicle and
attachments") is not required due to the central lubrication
system.
The central lubrication system has a lubricant tank that
must be filled by the operator.
CAUTION
Danger of environmental damage due to leaking lubri-
cants
Lubricants escaping during filling are harmful to the envi-
ronment!
Do not overfill the container (observe marking), watch out
for escaping lubricants when filling and wipe it up immedi-
ately.
WARNING
Please be sure to observe the original instructions en-
closed with the unit and the safety instructions contained
therein!
ATTENTION
Risk of damage
The unit can be damaged by incorrect filling!
Only refill the lubricant tank at the filling nipple.
ATTENTION
Risk of damage
Damage to the vehicle and attachments due to incorrect lu-
bricant!
Use only approved lubricant. See chapter "Technical data/
Lubricants" in the vehicle operating instructions.
The pump unit and the lubricant tank of the central lubrica-
tion system are installed in the rear of the vehicle and are
accessible via the rear cover of the left or right side of the
vehicle (depending on whether an additional water tank at-
tachment kit is installed).
56
Overview of the unit
(1)Filling nipple
(2)Filling level marking "Min"
(3)Filling level marking "Max"
Control unit
Note
The control unit is located under a cover with a sight glass.
Settings may only be made by the authorised service.
(1)Lubrication time
(2)Cycle time
(3)Indicator light green
(4)Indicator light red
(5)Diagnostic and service interface.
2.11.1Operation of the central lubrication system
Vehicle is parked, ignition switched on.
Note
The central lubrication system operates automatically ac-
cording to the set parameters. The operating status can be
read from the two indicator lights.
The unit is maintenance-free, except for the regular filling
of the lubricant tank.
CAUTION
Risk of injury
Lubricant escaping under pressure
Only disconnect the connections of the central lubrication
system when it is not in operation (lubrication cycle)!
Activities
1. Fill lubricant tank
a Check the filling level of the lubricant tank.
b Connect grease gun or filling pump to the filling nip-
ple.
c Fill the lubricant tank.
English