Publicité
Les langues disponibles
Les langues disponibles
4.13
FITTING THE SKIMMER
FRAME (M):
En sure that all holes are
lined up properly (seal to wall
plate perforation to skimmer).
Screw 10 remaining screws
loosely through the frame to
check that the f it is correct.
Then tighten the screws a lit-
tle more one by one in the or-
der indicated. Finally, tighten
them fully in the same order.
1º 10º 3º
8º
5º
6º
7º
4º 9º 2º
TS
TA
O
S
C
A
FILTER INLET PIPE
A
M
FILTER INLET PIPE
LAST DETAILS: Pressure f it
the trim part of the skimmer
frame (Z). To finish, introduce
the flap (K) through the rec-
tangular gap (delicately press
the two ends and fit the pro-
trusions). Place the basket
(O) into the skimmer and the
skimmer body cover (TS).
FINISH FILLING THE POOL
UP TO HALFWAY UP THE
SIMMER DOOR, (10-15 cm be-
low the pool edge) SO WATER
ENTERS INTO IT AND FILLS
THE FILTERING SYSTEM.
J
K
M
Z
E N
TS
S
15 cm
4 cm
K
WATER
Z
M
J
JOINT
GRILLE
SHEET
LINER PVC
2 3
Publicité
