GRE 83037503 Manuel De Montage page 330

assembly instructions
4.11
FITTING THE RETURN VALVE (V):
(IMPELLER NOZZLE: V)
This valve is located at the bottom of the pool
wall, and water is returned to the pool through
it after treatment in the treatment unit. Start
pouring water into the pool through a garden
hose, and stop 4 cm below the bottom of the
valve hole (check the liner is clean before filling
4 cm
4.12
ATTACHING THE SKIMMER BODY (S) TO
THE OUTSIDE OF THE POOL:
Fill the pool with water until the level is 4 cm
from the bottom of the perforation for the skim-
mer. Using a Stanley knife, cut the liner (L) in-
side the pool opposite the perforation. Locate
the double seal (J) so that the wall plate and
S
C
A
*
4 cm
L
2 2
the pool). Mark the position of the hole on the
liner with a felt pen and make a cross-shaped
cut in the centre of the mark with a stanley
knife or similar. Do not cut beyond the edge of
the hole. Place inside the pool through the cut,
with a seal (J) and a friction ring (F). Cut the pro-
truding part of the liner.
V
J F R
WATER
liner are within the groove (X) made for this
purpose and fit the two shorter screws into the
larger centre holes from the inside of the pool
through the double seal and the liner. Screw
them into the center holes on the skimmer (S).
Cover the connecting bushing (C) and the wa-
ter treatment unit inlet with Teflon. Screw the
connecting bushing (C) tightly to the skimmer,
CH L
X
F
TEFLON
T
A
M
+
J
Fit the other seal (J) and the other friction ring
(F) and tighten firmly with the nut (T). Insert the
return hose (M) which goes from the outlet of
the treatment unit to the return valve (V), and
secure it with the clamp (A).
CH L
connect one end of the hose to the skimmer
connecting bushing (C) using a clamp (A), and
f it the other end to the treatment unit inlet.
Clamp this end also.
NB.- Fit Teflon on all water hose connection
threads to ensure leak-tightness.
F
R
4 cm
WATER