GRE 83037503 Manuel De Montage page 328

assembly instructions
4.8
INSTALLATION OF THE UPPER PROFILES
(PLY):
Avoid that the PLY pieces fall into the pool du-
ringinstallation because they can damage the
liner. Place each PLY supported by two conse-
cutive PUs with round part outside. You will see
that each PLY has four holes (two inside and two
outside) for fixing to the joint pieces. Start by fi-
PLY PLAYA 2º
PU
4.9
2º
2 0
xing each PLY to the joint pieces but only finger
tightening the (and not fully tightening them
so there is some play among them) the inside
screws of each side (1º). After having placed all
the PLYs, re-check that the vertical profiles are
upright, if not, correct their position. Then con-
tinue positioning the outside screws (2º) and ti-
ghten all the screws to the structure.
1º T PLAYA
2º
PCF
PV
EM
1º
PLY
PV
Put the plastic plugs TPS (only for pools of
120 cm) on the screws (for protection) at the
outside of the pool.
ATTENTION: getting on, walking on, or sitting on
the PLYs is firmly prohibited, as well as jumping
or diving from the same.
TPS
* IMPORTANT! BEFORE ASSEMBLY, DE-
BURRING, USING A FILE AND SANDPA-
PER, THE ENDS OF EACH PLY.
PLACING THE FLEXIBLE JOINT PRO-
TECTORS EM: (only for 120 cm pools):
The flexible joint protectors are fitted to
the joints between the trim pieces. To fix
them, start by fixing the back part (inside
the pool) to the trim piece and with the
aid of a screwdriver lever the front ribs
over until they fit to the trim piece.