Publicité
Les langues disponibles
Les langues disponibles
assembly instructions
#4
Installation.
4.1
BOTTOM SECTION PIECES (PI) FOR ROUND
SWIMMING POOLS
NOTE: These curved SECTION PIECES ARE
FOR THE BOTTOMS of ROUND SWIMMING
POOLS. Take each bottom section piece (PI)
and fit a drop-forged part (PU) in the middle
(see photo A). Join the section pieces to one
another with the joining pieces (PIPC), leav-
ing a gap of about 1cm between them (see
photo B). Complete the circle with all the sec-
tion pieces. Begin fitting the wallplate in the
middle of a drop-forged part (PU) previously
positioned half way along each section piece.
If on completing the wallplate installation the
circle made by the section pieces is too small,
open out the section pieces until you achieve
the exact diameter. If, on the other hand, the
circle of section pieces is too big, you will have
to close them up until the circle matches the
diameter of the wallplate.
PI
Picture A
1 4
NOTE: (LO ) If the ground is not firm (con-
crete, etc.), it is advisable to set a tile or slab
into the ground under each part PU to pre-
vent the upright supports PV from sinking
under the weight of the water.
NOTE: Drop-forged parts PU under no
circumstances shall be aff ixed to the
ground by any means; in the event of do-
ing so, you run the risk of swimming pool
breakage and the automatic loss of the
warranty.
* Use duct tape to cover parts PU and
PIPC on the inside of the pool and thus
avoid that may damage theliner.
* Place the top rails (PLY) to estimate the
distance between (PU) pieces.
PU
PIPC
Picture B
PI
PU
PIPC
PI
PI
PIPC
LO
1cm
PI
PIPC
Picture C
PI
Publicité
