GRE 83037503 Manuel De Montage page 324

assembly instructions
4.4
ASSEMBLY OF THE PVC LINER:
EXTENDING THE LINER:
Important: The liner used in the manufactu-
ring of all our pools, is developed for exposi-
tion to heat and ultraviolet rays during long
periods. Therefore, under certain weather and
usage conditions, the liner qualities can slight-
ly vary. The interior liner of the pool is manu-
factured from flexible PVC (thermoplastic). Its
properties allow optima installation conditions
when the outside temperature is between 20
ºC and 25 ºC.
ºC
20º - 25º
SERIAL NO.;
1 6
NOTE: Temperature too low: hard and rigid
liner; later, too small. Temperature too high:
flexible and elastic liner; later, too big. Pull
and extend the liner (L) in the shade to re-
cover its texture, at least 2 hours before ins-
talling it. Ideal temperature: To manipulate
the liner better, try to do this at an outside
temperature between 20 - 25º C. Situate the
liner (L) at the center of the pool. Extend it
at the bottom and f itted against the side
towards the steel sheet. The welding that
joins the bottom with the side must be per-
fectly fitted against the lower profiles of the
LINER
SERIAL NO.
Examples
F PR301 2023365 1
F PR451 HY201 9 07
S P38 5F GP201 9 01
entire perimeter of pool bottom avoiding any
folds. It is very important that the liner is well
centered and extended.
NOTE: If there any folds in the bottom of the
liner, this is no reason for it to be changed be-
cause it is NOT a factory defect.
SERIAL No: Locate it on the bottom or wall of
the liner and write the serial No. in the box on
the instruction sheet for possible claims.