GRE 83037503 Manuel De Montage page 323

4.2
* IMPORTANT! BEFORE ASSEMBLY, DEBURR-
ING, USING A FILE AND SANDPAPER, THE
EDGE OF THE CLOSING WALL (CH).
NOTE: REFERENCES: K300WET AND K350WET
DO NIT HAVE PUNCH HOLES IN THE METAL
SHEET (CH) OF THE POOL.
Fit the wall plating CH vertically on a piece of card-
board (to avoid damaging the area prepared for
the installation). Make sure the square and pierced
piece is always located in the superior part and
face to dominating winds. Fit the plating extremi-
ty and the first profile (PI) together and make the
plating extremity correspond with the top of the
joining-piece PU. Now, you can unfold it introduc-
ing it in the profiles PI, working clockwise.
CH
PI
PU
4.3
PVC PROTECTIVE STRIP (INTERIOR POOL
COVERING):
Attach the PVC strip to the top nut at the joint of
the wall plate so that it hangs down inside the
pool to cover the screw heads.
TPVCP
Start to place the sheet at the middle of a pressed
part (PU) previously situated at the middle of each
profile, (see page 14). If when closing the sheet cir-
cle of the profiles it is small, all the profiles must be
separated from each other until obtaining the exact
diameter. On the other hand it is too bog, the profiles
should be moved closer to each other until equaling
the circle with the diameter of the sheet.
WARNING: If the surround is too large to close the
steel wall, even if the ground rails are completely
joined together, one of the rails must be cut.
Complete the circle and close the plating CH
thanks to the screws TT. The screwhead has to
stay in the interior part of the pool, the ring and
the blind nut in the exterior part (Tighten the
screws without distorting the material).
The Ground Cover or floor tapestry - Caution:
Clean all dirt from the pool wall and bottom with
a vacuum cleaner before placing the ground
cover or floor tapestry in position.
Fit the protective ground cover or floor tapestry
in the interior of the pool and smooth out all the
creases, adjusting and cutting away excess from
the total surface area. Cut so that the bottom
section pieces and the metal parts are covered.
This way the liner will be protected when you
install it.
MPR
TPVCP
E N
installation
TT
TPR
1 5