Télécharger Imprimer la page

Faber FMG3326F Manuel D'instructions page 71

Publicité

Maintenance
Log Replacement
The unit should never be used with broken logs . Turn off the gas valve and allow the unit to cool before opening
door and carefully remove the logs . (The pilot light generates enough heat to burn someone .) If for any reason a log
should need replacement, you must use the proper replacement log . The position of these logs must be as shown in
the diagrams under Log Installation .
!
NOTE: Improper positioning of logs may create carbon build-up and will severely alter the unit's
performance which is not covered under warranty.
Glass Gasket
If the glass gasket on the appliance requires replacement a graphite gasket specifically designed for this appliance is
required . This gasket is supplied with preinstalled self-adhesive tape .
There is also gasket installed on the edge of the inner glass to protect against breakage when installing the glass .
Glass
To clean fireplace glass, only a gas fireplace glass cleaner should be used . Do not use normal household (usually
ammonia-based) glass cleaners to clean the glass as these cleaners can leave a permanent stain . Do not use
abrasive materials or cleaners .
• Do not clean when the glass is hot .
• The use of substitute glass will void all product warranties .
• Care must be taken to avoid breakage of the glass .
• Do not strike or abuse the glass .
• Do not operate this fireplace without the glass front, or with a cracked or broken glass front .
• Wear gloves and safety glasses when removing damaged or broken glass .
• Replacement of the glass panels should be done by a licensed or qualified service person .
1 . Always turn off the gas valve before cleaning . For relighting, refer to lighting instructions . Keep the burner and
control compartment clean by brushing and vacuuming at least once a year . When cleaning the logs, use a soft
clean paint brush as the logs are fragile and easily damaged .
2 . Clean appliance and door with a damp cloth (never when unit is hot) . Never use an abrasive cleaner . The glass
should be cleaned with a gas fireplace glass cleaner . The glass should be cleaned when it starts looking cloudy .
71
WARNING
!
FaberFires.com

Publicité

loading