Publicité
WARNING
!
CARBON MONOXIDE POISONING HAZARD
Failure to follow the steps outlined below for
each appliance connected to the venting system
being placed into operation could result in carbon
monoxide poisoning or death . The following steps
shall be followed for each appliance connected to
the venting system being placed into operation,
while all other appliances connected to the venting
system are not in operation:
1 . Seal any unused openings in the venting system .
2 . Inspect the venting system for proper size and
horizontal pitch, as required in the National Fuel
Gas Code, ANSI Z223 .1/NFPA 54 or the National
Gas and Propane lnstallation Code, CSA B149 .1
and these instructions . Determine that there is
no blockage or restriction, leakage, corrosion
and other deficiencies which could cause an
unsafe condition .
3 . As far as practical, close all building doors and
windows and all doors between the space in
which the appliance(s) connected to the venting
system are located and other spaces of the
building .
4 . Close fireplace dampers .
5 . Turn on clothes dryers and any appliance not
connected to the venting system . Turn on
any exhaust fans, such as range hoods and
bathroom exhausts, so they are operating at
maximum speed . Do not operate a summer
exhaust fan .
6 . Follow the lighting instructions . Place the
appliance being inspected into operation .
Adjust the thermostat so appliance Is operating
continuously .
7 . Test for spillage from draft hood equipped
appliances at the draft hood relief opening after
5 minutes of main burner operation . Use the
flame of a match or candle .
8 . If improper venting Is observed during any of
the above tests, the venting system must be
corrected in accordance with National Fuel Gas
Code, ANSI 2223 .1/NFPA and/or Natural Gas
and Propane Installation Code, CSA B149 .1 .
9 . After it has been determined that each appliance
connected to the venting system properly vents
when tested as outlined above, return doors,
windows, exhaust fans, fireplace dampers and
any other gas-fired burning appliances to their
previous conditions of use .
WARNING
!
Due to high temperatures, the appliance should be
located out of traffic and away from furniture and
draperies .
Children and adults should be alerted to the hazards
of high surface temperature and should stay away
to avoid burns or clothing ignition .
WARNING
!
This appliance must be electrically wired and
grounded in accordance with local codes, or in
the absence of local codes, with National Electric
Code ANSI/NFPA 70-latest edition or the Canadian
Electric Code CSA C22 .1 . A 110–120 V AC circuit
for this product must be protected with ground-
fault circuit-interrupter protection, in compliance
with the applicable electrical codes, when it is
installed in locations such as in bathrooms or near
sinks .
WARNING
!
Young children should be carefully supervised
when they are in the same room as the
appliance. Toddlers, young children and others
may be susceptible to accidental contact burns.
A physical barrier is recommended if there are at
risk individuals in the house. To restrict access to
an appliance or stove, install an adjustable safety
gate to keep toddlers, young children, and other
at risk individuals out of the room and away from
hot surfaces.
Faber requires installation be performed
by an NFI-certified installer or a certified
Faber installer . Installations that do not
follow this instruction will not be covered
by warranty or serviced .
We recommend removing the glass with the suction
cups supplied by the manufacturer . When glass is
cooled, lower the glass to rest in a safe place . This
is to prevent damage to the glass edges . Extra care
must be taken when removing/installing the glass .
Breakage or damage to the edge of the glass which
occurs as a result of careless handling will not be
covered under warranty .
6
Publicité
