Publicité
Installation Steps
1 . Prior to starting the installation, make sure you read and understand all WARNING information in this manual .
Do not start the installation if you are unclear about any of the installation-related subjects .
2 . Determine the following:
• The vent system configuration to be used based on the fireplace location .
• Clearance requirements from combustible and non-combustible materials .
• Gas supply piping .
• Electrical wiring requirements .
• Framing and finishing details .
3 . Unpack the fireplace box, following instructions for fireplace unpacking .
4 . Put the fireplace in the desired location . Verify clearance to non-combustible and combustible materials . Follow
the clearance instructions in this manual .
5 . Attach the brackets of the unit to the wall framing
6 . Connect the vent system to the fireplace .
7 . Connect the gas line to the fireplace and verify gas inlet and outlet pressure .
8 . Confirm if adjustments for high altitude are needed (installation at above 4500 ft from sea level) .
9 . Install receiver batteries or if using mains power, ensure electrical outlet is within 2 .5m and plug AC/DC adaptor
to receiver and to wall receptacle .
10 . Insert and place Fireplace media . Use media arrangement guide from the manual .
11 . Verification of:
• Ignition and pilot system .
• Burning and flame .
• Remote control Setup
12 . Complete framing and wall cover .
13 . Remove blue protective film from glass and clean glass .
14 . Re-install the glass, and unpack and install the safety barrier .
15 . Ensure the homeowner is familiar with operation of the fireplace and remote control, and can locate the the
ignition instructions and rating label .
16 . Ensure the homeowner has paperwork showing the details of the fireplace (model, serial number, installation
date) and the details of the installer .
17 . Ensure the homeowner is aware of regular maintenance schedules and potential problems that will require
service .
Read all the instructions before starting the installation. Follow these instructions carefully
during the installation to ensure maximum safety and benefit. Follow the steps above to
ensure proper installation of the gas appliance.
WARNING! Risk of fire or explosion! Damaged parts could impair safe operation.
DO NOT install damaged, incomplete or substitute components.
25
WARNING
!
FaberFires.com
Publicité
