Automatic Time Setting; Manual Time Setting And Other User-Defined Settings; Alarm Setting - Bresser WIFI 4Cast Guide Rapide

• Under your phone settings -> Apps & notifications --> Permissions -> WeatherSense, Make sure
your phone location services are turned on. Go to "set individual permissions", Make sure "access
location info" and "Access list of installed apps" service are turned on.
• Make sure your phone BLUETOOTH function is on. Refresh in the device list until "weathertype"
appears in the new device list.
• Try re-pairing again, by restarting your phone WLAN function, app and weather Station device.
Q: Why does the app notify "The device is already bound by another account"?
• The device has been reconfigured or tested in the factory.
• Reconfigure the device with your home WIFI network.

12 Automatic time setting

After the power supply and the Wi-Fi connection are established, the time and date information is
automatically transmitted by the Internet time server.
If the reception is correct, the date and time are set automatically and the time transfer icon will be dis-
played.
If there is no automatic time setting, there may be a problem with the Wi-Fi connection. Read the
chapter "Troubleshooting" for possible solutions.
If the automatic time setting furthermore is not working, the time must be set manually. Please read
the chapter "Manual time setting and other user-defined settings".
13 Manual time setting and other user-defined
settings
1. Press the Settings/Brightness key for approx. 3 seconds to enter the settings mode.
2. Digits to be set are flashing.
3. Press UP/CH key or DOWN/WIFI key to change the setting.
4. Press the Settings/Brightness key to confirm and switch to the next setting.
5. Settings sequence: Temperature unit (°C or °F) > Air pressure unit (hPa or mb) > Wind speed unit
(km/h or mph) > 12 or 24 hour mode > Time zone (-12 to +12 hours) > Hours > Minutes > Date
display (M/D or D/M) > Year > Month > Day > Language of weekday information
6. Finally, press the Settings/Brightness key to save the settings and exit settings mode.
NOTICE! If no setting is made within 20 seconds, all settings made up to that point are saved
and the base station will switch back to normal display mode. For manual time setting, the Wi-Fi
connection must be disconnected.

14 Alarm setting

1. Press the Alarm key to display the alarm time.
2. Press the Alarm key for approx. 2 seconds to enter the alarm time settings mode.
3. Digits to be set are flashing.
4. Press UP/CH key or DOWN/WIFI key to change the setting.
5. Press the Alarm key to confirm and switch to the next setting.
6. Settings sequence: Hours > Minutes > Snooze interval (5 to 60 minutes or OFF)
7. Finally, press the Alarm key to save the settings and exit settings mode.
8. Move the alarm slider to
The alarm is enabled.
30 / 56
position to enable the alarm. The symbol will displayed on the LCD.