Automatic Time Setting - Bresser Thermo Hygro Quadro NLX Mode D'emploi

8.
Remote sensor
9.
10. Insert the batteries into the battery compartment. En-
11. Set the channel selector switch to the desired channel.
12. Replace the battery compartment cover.

9 Automatic time setting

After the power is restored, the unit automatically searches
for the radio signal. It takes about 3-8 minutes to complete
this process.
If the radio signal is received correctly, the date and time
are set automatically and the reception symbol is displayed.
If no radio signal is received, proceed as follows:
1.
14 / 88
Wait until the indoor temperature is displayed on the
base station.
NOTICE! When switching from mains power supply
to battery power supply or vice versa, the power
supply is being disabled for a short moment for
technical reasons. Exception: permanent battery op-
eration.
Remove the battery compartment cover.
sure that the battery polarity (+/-) is correct.
NOTICE! This weather station can be operated with
one or more remote sensors. Each remote sensor
being connected must be operated on a different
channel. If only one remote sensor is connected, it
should be operated on channel 1.
Press the DOWN button for approx. 2 seconds to initi-
ate the reception of the radio signal again.