Automatic Time Setting; Alarm Settings - Bresser ClimaTemp FSX Guide Rapide

Remote sensor
5.
6.
7.
8.
NOTICE! When operating one outdoor sensor, channel 1
is recommended as the default setting.

9 Automatic time setting

After the power supply was established, the clock will auto-
matically search for the radio signal. This will take approxim-
ately 3 to 8 minutes to finish this process.
If the radio signal is received correctly, the date and time
will be set automatically and the radio control signal icon
turns on.
If the clock fails to receive the time signal, go ahead with the
following steps:
1.
2.

10 Alarm settings

1.
12 / 88
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Move the CH slide control to the position for the desired
transmission channel (setting CH1, CH2 or CH3 with
screen display).
Replace the battery compartment cover.
Press °C/°F button on the base station for approx. 3
seconds to initate RC signal reception again.
If the device is still not receiving the signal, the time
must be set manually.
In normal display mode, press the TIME button several
times to display the Alarm time AL1 or AL2.