Installation Procedure - Arneg LAVAL Manuel D'installation Et De Service

Cabinet make sure the packing is intact and that it does not display readily apparent
damages;
delivery
carefully perform the unpacking operation in order not to damage the
cabinet;
check that cabinet components are intact
should you notice any damage immediately inform the manufacturer
Installation
Step
procedure
1
2
3
4
5
6
7
8
9
before connecting the cabinet to the electrical line, make sure that the rating plate data
matches the characteristics of the electrical system to which the cabinet must be
attached.
if the cabinet is moved to another located, repeat levelling,
incorrect levelling leads to incorrect operation of the cabinet
level the cabinet both in front and back
DO NOT install the cabinet (Fig. 4):
- in areas at risk of explosion
- in open air and therefore subjected to atmospheric agents;
- near heat sources (direct sunlight, heating systems, incandescence lamps, etc.)
- near air currents (near doors, windows, air-conditioning systems, etc.) that exceed
a speed of 0.2 m/s
Firts cleaning gently remove the protective film, eliminate glue residues with suitable
solvents
carry out the first cleaning using neutral products, dry with a soft cloth
ATTENTION! Abandoned packaging parts. Injuries.
DO NOT leave parts of the package (nails, wood, paper clips, etc. ) and tools used for the
operation (pliers, scissors, etc. ), on the work area.
These objects must be removed with appropriate means and brought to their
respective collection places.
i
For correct disposal, the package consists of:
Wood - Polystyrene - Polythene - PVC - Cardboard.
05060156 00 22/10/2014
carefully examine the installation area, eliminating any danger to the
operator
remove the package only if the cabinet is placed in the
operation area
lift the cabinet safely
use suitable scissors to cut the clip tightening straps-A-
remove the clips and the frame
lower and place the cabinet in the area of use
adjust the horizontal position of the cabinet using a spirit level (Fig.8)
check that all feet are into contact with the floor
level the cabinet both in front and back
DO NOTuse alcohol to clean the parts in methacrylate (Plexiglas).
DO NOT use abrasive substances or metal sponges
Rodi-Laval-Gander
Action
English
45