Identification - Nameplate (Fig. 2); Transportation (Fig. 3); Receipt And First Cleaning; Installation And Environmental Conditions (Fig. 3) - Arneg ULM 3 Manuel D'installation Et D'emploi

4. Identification - Nameplate (Fig. 2)

The technical nameplate is situated on the back of the cabinet with all the technical characteristics:
1 Manufacturer's name and address
2 Name and length of the cabinet
3 Cabinet code number
4 Cabinet registration number
5 Power supply voltage
6 Power supply frequency
7 Current absorbed at steady state
8 Electric power absorbed at steady state during refrigerating phase (fans + hot cables +
illumination)
9 Electric power absorbed at steady state during defrosting phase (armored heating elements + hot
cables + fans + illumination)
10 Illuminating power (where applicable)
11 Useful display surface
12 Type of refrigerating gas used in the appliance
13 Mass of refrigerating gas loaded in each appliance (only for cabinets with incorporated motor)
14 Environmental climatic class and reference temperature
15 Class of protection against humidity
16 Manufacturing job number of the cabinet
17 Manufacturing order number of the cabinet
18 Manufacturing year of the cabinet
In case of technical service request, please communicate the following information for the
identification of the cabinet:
- product name
- registration number
- job number

5. Transportation (Fig. 3)

The cabinet is fitted with a wooden support fixed to the base for handling by means of fork-lifts.
Use a manual or electric lift truck suited for raising the cabinet in question (Rif. 3).

6. Receipt and first cleaning

Upon receipt of the cabinet:
- Make sure that the packaging is intact and that it is not evidently damaged;
- Unpack the cabinet with care so as not to damage the cabinet itself;
- Check each single part of the cabinet making sure that all its components are intact;
- If anything is found to be damaged, immediately call the supplying company;
- Proceed with a first cleaning using neutral products, dry with a soft cloth, do not use abrasive
substances or metal sponges;
- DO NOT use alcohol to clean parts in metacrylate (plexiglas).
For correct packaging disposal, remember that it contains:
Wood - Polystyrene - Polythene - PVC - Carton.
In compliance with EEC Directive 94/62 we hereby approve the materials above.

7. Installation and environmental conditions (Fig. 3)

For installation, follow the instructions below:
- Do not position the cabinet:
in places containing explosive gaseous substances;
in the open air and, therefore, exposed to atmospheric agents;
near sources of heat (direct sunlight, heating appliances, incandescent lights, etc.);
near air currents (near doors, windows, air-conditioning systems, etc.) that should not exceed the
speed of 0.2 m/s.
- Remove the wooden supports on the base (used for transportation) and mount the adjustable feet
(Rif. 2) regulating them so as to position the cabinet horizontally; use a level (Rif. 1) to make sure of
its positioning.
05060078 00 01/06/2007
(Fig. 2 - 2);
(Fig. 2 - 4);
(Fig. 2 - 18).
Ulm 3
English
19