Pushing Aid; Using The Pushing Aid; For Add-On Bikes; Date And Time - Sunrise Medical QUICKI Attitude Notice D'utilisation

Pushing aid:

Fig.3.10
Should you require motorised support when pushing, for
example on steep hillsides, then you can activate the
pushing aid. To do this, while you are in the start menu
(see section 3.2.2), press button [2] on the controller to
move to the next sub menu. There, select "menu" and in
the next selection screen that appears, select "pushing
aid". You can activate or deactivate the pushing aid in the
next window that opens.
Once you have set the required function, go back to the
start menu by pressing button [1] of the controller several
times. An activated pushing aid is shown in the start
menu by the symbol [13].

Using the pushing aid:

For add-on bikes:

The pushing aid is used by pressing button [1] for a
pushing aid forwards or button [3] for a pushing aid
backwards.
This turns on the motor and moves your add-on bike at a
maximum speed of 6 km/h (forwards) or 4 km/h
(backwards) for as long as you are holding down the
respective button ([1] or [3]). This is shown in field [13] as
a white bar element.
For add-on bikes:
If buttons [1] or [3] are released, the motor switches off. It
can only cut in again if add-on bike is idle.
If the pedals are moved during pushing, the sMMI
automatically switches to the mode of the pre-set
assistance level (see section 3.2.4) so that the
selection activated for this level is available from a speed
of about 8 km/h.
If the pedals are not moved, the sMMI switches back to
the pushing aid below a speed of 8 km/h.
If the sMMI is switched off, the activated pushing aid is
retained in the program and is immediately ready for use
upon start-up. However, after start-up the drive wheel
must complete 2 to 3 revolutions before the motor moves
the add-on bike when pressing button [1] or [3].
The maximum speed of the pushing aid can be set
according to your requirements by your specialist dealer.

Date and time:

The date and time can also be set individually.
The set time is shown in field [12] of the start menu
whereas the date is only used for internal calculations in
the sMMI.
As already seen in the functions described in previous
sections, you can also set the date and time in the known
way from the start menu in the various sub menus (see
also the overview in section 3). You can modify the
required parameters here.
Attitude/Attitude Hybrid Rev.2.0
31