Publicité
Les langues disponibles
Les langues disponibles
After operation
WARNING
If the device is off, left-over in the device can still be under high pressure.
CAUTION
•
•
•
1.
Release the trigger (Figure 7, pos. 2).
2.
Lock the safety lock under the trigger (Figure 7, pos. 1).
3.
Switch the device off (Figure 5, pos. 10).
4.
Pull the power plug out of the socket (Figure 5, pos. 7).
5.
Wind the power cable.
6.
Place the power cable on the bracket (Figure 5, pos. 1).
7.
Close and disconnect the water supply.
8.
Unlock the safety lock under the trigger.
9.
Hold the jet gun with both hands.
10. Squeeze the trigger to drain the jet gun.
11. Screw the high-pressure hose off from the jet gun (Figure 7, pos. 3).
12. Drain the high-pressure hose for at least 1 minute.
Remove the nozzle
1.
Screw the nozzle off from the jet gun.
Remove the floor cleaner
1.
Screw the floor cleaner lance off the jet gun.
2.
Remove the floor cleaner from the floor cleaner lance by rotating it 90°.
Transport and storage
WARNING
Completely empty the device and accessories. Protect the device from frost.
Left over water can freeze and damage the device.
•
Move the device by the handle (Figure 5, pos. 12).
•
Clean the device before storing it.
•
Store the device in its original packaging in, dry and dust-free area.
Prepare for winter / frost-free storage
1.
Clean the device.
2.
Make sure there is no left-over water in the device.
3.
If possible, store the device and accessories in a frost-free of frost-protected room. If
not; suck in anti-freeze before you store it. Use the anti-freeze instead of water.
Do not use the power cable to unplug or carry the device.
Do not wind the power cable too tightly or in sharp angles.
Do not wrap the power cable around the device.
47
Publicité
