Publicité
Les langues disponibles
Les langues disponibles
Floor cleaner
1.
Align the ridge of the floor cleaner (Figure 14, pos. 4) with the groove in the floor cleaner
lance (Figure 14, pos. 5).
2.
Insert the floor cleaner (Figure 14, pos. 3) into the floor cleaner lance (Figure 14, pos. 2).
3.
Turn the floor cleaner 90° to secure the extension lance.
4.
Screw the floor cleaner lance on the jet gun (Figure 14, pos 1).
Figure 14
Operation
WARNING
Before operating, see section Safety.
WARNING
Operating the device more than 2 minutes without water leads to damage of
the high-pressure pump. If the appliance does not build up pressure within 2
minutes, switch the appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting".
CAUTION
If the lever of the jet gun is released, the pressure switch turns off the pump
and the high-pressure jet stops. The pump switches on again when the lever is
pressed.
44
Publicité
