Publicité
Les langues disponibles
Les langues disponibles
SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Change Master Code
The Master Code is needed to enter programming mode. The equipment leaves the
factory with a default Master Code. It can be changed as follows.
1. Enter PROGRAMMING mode
Key in the default Master code, 1480
2. Key in "A 0 "
See NOTE below
3. Key in new Master Code
The number of digits in the new code must
coincide with the number length set in the system.
4. Exit PROGRAMMING mode
Key in "AA" to exit program mode.
System
also
automatically after 20 seconds inactivity.
NOTE:
If you forget the Master code, it can be replaced by the original 1480, as explained
in this manual.
All manuals and user guides at all-guides.com
exits
programming
1480
A 0
M M M M
mode
A A
beep-beep
beeeep
beep-beep
Pag 9
Publicité
