Fermax MEMOKEY 100C Manuel page 6

SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Set user codes length
Initially, user codes have 4 digits, including the MASTER code.
For enhanced security, they may be changed to 5 or 6 digits, or 3 digits for greater ease.
(See NOTES below).
The steps are as follows:
1. Enter PROGRAMMING mode
Key in the Master code, 1480 by default, although
this can be changed if you wish, as shown in this
manual.
2. Key in " A 4".
3. Indicate the new length (3, 4, 5 or 6).
4. Key in " A A" to exit PROGRAMMING
System also
automatically after 20 seconds inactivity.
NOTES:
If user code length is changed after programming to a higher number of digits,
the existing codes will have extra zeros appended at the end to adapt to the new
length. This will also affect the MASTER Code and the Free Access Code.
If user code length is changed after programming to a lower number of digits,
existing codes will have their final digits truncated.
Pag 6
All manuals and user guides at all-guides.com
exits programming
1480
A 4
3, 4, 5 or 6
mode
A A
beep-beep
beeeep
beep-beep