Publicité
Les langues disponibles
Les langues disponibles
SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Add or edit user codes
Codes are stored in memory in this order: position - code - action, as follows:
1. Enter PROGRAMMING mode
Key in the Master code, 1480 by default, although
this can be changed if you wish, as shown in this
manual.
2. Key in the position.
This can be any number from 00 to 99.
See NOTE
3. Key in the new code
Number of digits must coincide with digit number
length set in the system.
4. Key
in
1: Door will open.
2: Auxiliary device activates if present.
3: Door opens and auxiliary device activates
simultaneously.
5. Exit PROGRAMMING mode
If you want to enter more codes go straight to step
2, if not simply key in "AA" to exit programming
mode.
System
also
automatically after 20 seconds inactivity.
NOTES:
If the position to be set is already taken up, the new code cancels the previous
one. This is also valid for the factory preset codes, in positions 00, 01 and 02.
It is very important to make a list of the codes with their position and action.
All manuals and user guides at all-guides.com
below.
the
associated
exits
programming
1480
00...99
CCCC
action.
1, 2 or 3
A A
mode
beep-beep
beeeeep
beep-beep
Pag 7
Publicité
