Fermax MEMOKEY 100C Manuel page 15

SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Reset MASTER code (if previous code forgotten)
This operation is done by electrical manipulation of the equipment, to ensure that it cannot
be modified by anyone without physical access to it.
1. Disconnect the system power source.
2. Make a short circuit between terminals "S1" and "-" of the equipment.
If the system has an exit pushbutton, simply keep it pressed.
3. Reconnect the system power source and remove the short circuit (or release the exit
button). You have 20 seconds to enter a new MASTER code.
NOTE:
Replacing the MASTER code does not erase the rest of the information programmed
in the system.
All manuals and user guides at all-guides.com
DL1
MEMOKEY 100 CODIGOS
CN4
MEMOKEY 100 CODES
REF. 2520
SW1
C1 R1
REMOTE
F - Pl Ck So Bz C1 R1 S1 - S2 C2 R2 A
S1 - S2 C2
Pag 15