Fermax MEMOKEY 100C Manuel page 12

SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Programming indoor pushbuttons
The system may also be equipped with one or two pushbuttons (PI1, PI2) which, installed
inside the premises, allow the door to be opened from the inside or set off any additional
electrical device that has been installed.
These pushbuttons can be enabled or disabled, as follows:
1. Enter PROGRAMMING mode
Key in the Master code, 1480 by default, although
this may be changed if you wish, as shown in this
manual.
2. Key in "A 5 " to select PI1 or:
Key in "A 6 " to select PI2
3. Key in "1" to enable pushbutton selected or
Key in"0" to disable it
4. Exit PROGRAMMING mode
Key in "AA" to exit programming mode. System
exits programming mode automatically after 20
seconds inactivity.
Pag 12
All manuals and user guides at all-guides.com
beep-beep
1480
A5orA6
beeeep
0 or 1
beep-beep
A A