Fermax MEMOKEY 100C Manuel page 4

Les langues disponibles

SISTEMAS

MEMOKEY 100C

Default codes

For their use, codes are stored in the memory in the following sequence:

POSITION: Number assigned to each code in memory (del 00 al 99)

CODE: Number to enter through keypad to carry out the indicated action.

ACTION: What happens after code is entered correctly.

So that the system is up and running, with no need to set any codes, it leaves the factory with

three pre-programmed codes, as shown in the table:

POSITION

(*)

These codes are indicated by a label on the back of the keypad module.

NOTES:

Preset codes are exclusive to each set of equipment, so only you will know them.

However, you can change them if you wish.

Initially, user codes have 4 digits. For enhanced security, they may be set to 5 or

6 digits length. In this case, the preset codes will no longer be valid.

Pag 4

All manuals and user guides at all-guides.com

POSITION - CODE -ACTION

CODE

CODE 1 (*)

CODE 2 (*)

CODE 3 (*)

OPEN DOOR

ACTIVATE AUXILIARY DEVICE (if present)

OPEN DOOR AND ACTIVATE AUXILIARY DEVICE

ACTION