Publicité
Les langues disponibles
Les langues disponibles
SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Enable user own code change
It is possible to allow the users to change the access code assigned to them for another
personal code. To do this the feature must be enabled.
Here is how to do it:
1. Enter PROGRAMMING mode
Key in the Master code, 1480 by default, although
this may be changed if you wish, as shown in this
manual.
2. Key in "A 7 "
3. Key in "1" to enable permit or
Key in "0" to disable it.
4. Exit PROGRAMMING mode
Key in "AA" to exit programming mode. System
exits programming mode automatically after 20
seconds inactivity.
NOTE:
Instructions for users to set their own code are given in the User Manual.
Pag 10
All manuals and user guides at all-guides.com
beep-beep
1480
A 7
beeeep
1 or 0
beep-beep
A A
Publicité
