Fermax MEMOKEY 100C Manuel page 14

SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Programming wildcard output
This equipment has a free contact auxiliary output to which a 6 Vdc device may be connected
with a maximum current of 300 mA to carry out several functions. If the equipment to be
connected does not comply with these specifications, a relay must be used (Ref. 2013).
See Installer's Manual.
The utility of this wildcard output can be defined in the following steps:
1. Enter PROGRAMMING mode
Key in the Master code, 1480 by default, although
this may be changed if you wish, as shown in this
manual.
2. Key in "A 8 "
3. Select the utility desired.
0: Wildcard output not used (by default)
1: Every time a valid code is entered a 1-second
pulse is generated.
2: Each time a valid code is entered the wildcard
output is activated, staying on for 5 seconds
longer than the associated device.
3: The wildcard output switches every time a valid
code is entered.
4. The wildcard output is activated and stays on
every time "A" is pressed along with another
keypad code (valid or not).
5. The wildcard output is activated after 3
consecutive wrong codes are entered, and stays
active for 4 minutes or until a valid code is
entered.
6. The wildcard output is activated when any key is
pressed and switches off after 15 seconds
inactivity.
4. Exit PROGRAMMING mode
Key in "AA" to exit programming mode. System
exits programming mode automatically after 20
seconds inactivity.
Pag 14
All manuals and user guides at all-guides.com
beep-beep
1480
A 8
0,...,6 beeeep
beep-beep
A A