Fermax MEMOKEY 100C Manuel page 16

SISTEMAS
MEMOKEY 100C
MEMOKEY 100C
Troubleshooting table
SYMPTOM
•
If the equipment does not
respond to programming.
SOUND
beep-beep
beeeep
maaawc
Pag 16
All manuals and user guides at all-guides.com
1. DISCONNECT the POWER SOURCE and enter the
sequence again.
2. Make sure the codes entered have the programmed
length. To check this, press a number key repeatedly
until the confirmation sound (
error sound (
number of digits will correspond to the number of
times it had to be pressed.
Enter PROGRAMMING or
Exit PROGRAMMING MODE
CONFIRMATION
Wrong data
CHECKS
maaawc
) is heard. The
ACTION
beeeep
) or