Power Fist 9113465 Mode D'emploi page 6

9113465
smoothly under no load, but does not run smoothly under load, then
excessive pressure is being used.
8. Do not touch an operating motor. Motors can operate at high temperatures
and can cause a burn injury.
9. Only use accessories that are specifically designed for use with the tool.
Ensure the accessory is tightly installed.
10. Only use an accessory that exceeds the No Load Speed rating
(see Specifications).
CUTTING TOOL PRECAUTIONS
WARNING! Some surfaces contain materials which can be toxic. When working
on materials that may contain lead, asbestos, copper chromium arsenate or
other toxic materials, extra care should be taken to avoid inhalation and
minimize skin contact.
The term cutting accessory is used to represent a cutting blade, cutting wheel
or a cutting bit.
1. Never force the tool' s cutting accessory to cut. Forcing the tool will slow
down the speed of the cutting accessory, causing it to bind or kickback.
Apply gentle pressure and allow the cutting accessory to do the cutting.
2. Never use a dull or damaged cutting accessory.
a. A dull or improperly set cutting accessories produce a narrow kerf that
can cause excessive friction on the cutting accessory, resulting in
binding or a kickback. Keep the cutting accessory' s edge sharp
and clean.
b. A dull cutting accessory requires more force to use the tool, possibly
causing the accessory to break. This may cause an injury.
3. Only use a cutting accessory of the recommended size (see Specifications).
4. Use the correct mounting hardware. The mounting hardware is designed
to hold the cutting accessory on the tool to allow optimum performance
and safety of operation. Mismatched mounting hardware may result in a
tool malfunction and cause an injury.
5. Do not touch the cutting accessory or the workpiece surface cut with this
tool. They may be hot and could inflict a burn injury.
6
4 x 6 in. Metal Cutting Band Saw
For technical questions call 1-800-665-8685
V1.0