Power Fist 9113465 Mode D'emploi page 27

V1.0
To change oil in the Gear Box:
1. Position the Body Frame (#93) in the horizontal
position (Fig. 26).
2. Remove four Bolts (#111), Spring Washers (#7), and
Flat Washers (#8). Remove the Gear Box Cover
(#110) and Gear Box Gasket (#109) (Fig. 30).
3. Remove the old oil from inside the Gear Box and
replace the oil using 140 weight gear oil. The new
oil should just come to the edge of the Gear Box.
Do not overfill (Fig. 31).
4. Replace the Gear Box Gasket, Gear Box Cover and
four Spring Washers, Flat Washers and Bolts.
STORAGE
Always lower the Body Frame (#93) to its horizontal position and insert the
Locking Pin (#126) into the Body Frame to secure in place when not in use or
when transporting the Band Saw
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing uncontrolled
discharge of waste oil.
Visit www.princessauto.com for more information
4 x 6 in. Metal Cutting Band Saw 9113465
Fig. 30
Fig. 31
27