Publicité
Les langues disponibles
Les langues disponibles
V1.0
Tool operates
Extension cord too long or
slowly.
wire size too small.
Performance
1.
decreases
over time.
2.
Excessive
Internal damage or wear
noise or
(carbon brushes or bearings,
rattling.
for example).
Excessive
1.
Blade
2.
breakage.
3.
4.
5.
6.
7.
Premature
1.
Blade dulling.
2. Saw Blade turns too
3.
4.
5. Insufficient Saw Blade
Visit www.princessauto.com for more information
4 x 6 in. Metal Cutting Band Saw
Saw Blade dull or
damaged.
Carbon brushes worn
or damaged.
Saw Blade is loose.
Saw Blade turns too
quickly or too slowly.
Vise is not gripping the
workpiece.
Wheel Flange is eroding
Saw Blade.
Saw Blade teeth are
spaced too widely for
the workpiece material.
Saw Blade is not
permitted to reach full
speed before workpiece
is fed into it.
Blade Guides are poorly
aligned.
Saw Blade teeth are
spaced too widely for
the workpiece material.
quickly.
Body Frame descends
too lightly.
Saw Blade installed
backwards.
tension.
Eliminate use of extension cord. If an
extension cord is needed, use one with the
proper diameter for its length and load.
1.
Replace Saw Blade.
2.
Have qualified technician replace
brushes.
Have technician service tool.
1.
Tighten Blade tension.
2.
Check manual for correct Blade speed.
3.
Clamp workpiece securely.
4.
Adjust Saw Blade tracking.
5.
See Replacing the Saw Blade with
recommended Blade type.
6.
Allow Blade to reach full speed before
feeding material into it.
7.
Adjust Blade Guides.
1.
Check manual for recommended
Blade type. Replace with appropriate
Saw Blade.
2. Try next lower speed.
3.
Increase pressure by reducing spring
tension on side of saw.
4.
Reinstall Saw Blade properly.
5. Gradually increase Saw Blade
tension until optimal tension has
been achieved.
9113465
29
Publicité
