Power Fist 9113465 Mode D'emploi page 19

V1.0
1. Adjust the Band Saw speed to its slowest
setting (see Adjusting the Cutting Speed).
2. Remove the Locking Pin (#126) from the
Body Frame (#93).
3. Raise the Body Frame to its full vertical
position. Turn the Support Plate (#127)
clockwise until it firmly locks into the
Body Frame and insert the Locking Pin to
lock Body Frame into position (Fig. 9).
4. Remove the Screw (#142) and Flat
Washer (#141) to open the Blade Back
Cover (#82). Turn on the Band Saw and
examine the Upper Blade Wheel (#83).
5. The Saw Blade (#66) is tracking properly
when the back of the Blade is just touching
the edge of the Upper Blade Wheel Flange
(Fig. 19-1). The back of the Blade should not
rub against the flange.
6. Turn off the Band Saw and loosen two
Bolts (#13) to a point where they are loose,
then tighten until snug (Fig. 20).
7. Restart the band saw and turn the Set Screw
(#96) until the Saw Blade tracks properly.
Make sure Blade tension is maintained by
turning the Blade Tension Adjusting
Knob (#91).
8. Turn off the Band Saw and retighten the two Bolts, when the adjustment
is complete.
9. Close the Blade Back Cover and secure with the Screw and Flat Washer.
ADJUST THE BLADE TENSION
NOTICE! Release the blade tension when the Band Saw will not be used
for extended periods of time. This will prevent damage to the blade and
saw mechanism.
Visit www.princessauto.com for more information
4 x 6 in. Metal Cutting Band Saw
19-1
9113465
Fig. 19
Fig. 20
19