Publicité
Les langues disponibles
Les langues disponibles
9113465
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Possible Cause(s)
Problem(s)
Tool will not
1.
start.
2. No power at outlet.
3.
4.
Overheating.
1.
2.
3.
4.
5.
6.
7.
8.
9.
28
4 x 6 in. Metal Cutting Band Saw
Cord not connected.
Tool' s thermal reset
breaker tripped (if
equipped).
Internal damage or wear
(carbon brushes or
switch, for example).
Forcing machine to
work too fast.
Saw Blade dull or
damaged.
Blocked motor housing
vents.
Motor strained by a too
long or small diameter
extension cord.
Saw Blade tension is
too high.
V-Belt tension too
high.
Blade is too coarse or
too fine for workpiece.
Gear not aligned
properly.
Gears need lubrication.
Suggested Solution(s)
1.
Check that cord is plugged in.
2. Check power at outlet. If outlet has
power, turn off tool and check circuit
breaker. If breaker is tripped, make
sure circuit is right capacity for tool
and circuit has no other loads.
3.
Turn off tool and allow to cool. Press
reset button on tool.
4.
Have technician service the tool.
1.
Allow machine to work at its own
rate.
2.
Replace Saw Blade.
3.
Blow dust out of motor using
compressed air.
4.
Eliminate use of extension cord. If
an extension cord is needed, use
one with the proper diameter for
its length and load.
5.
Gradually adjust Saw Blade tension
until optimal tension has been
achieved.
6.
Gradually adjust V-Belt tension
until optimal tension has been
achieved.
7.
See Replacing the Saw Blade for
recommended Blade type.
8.
Adjust Gears so that Worm is in
center of Gear.
9.
Check oil bath.
For technical questions call 1-800-665-8685
V1.0
Publicité
