Publicité
Les langues disponibles
Les langues disponibles
V1.0
Minute (FPM). This depends on the type of material being cut. Refer to Table 1
to determine the proper cutting speed.
2.
Adjust the cutting speed by changing the position of the V-Belt on the pulleys:
a.
Loosen the Bolt (#108) and press the Motor (#115) toward the Body (Fig. 8).
b.
Place the V-Belt around the desired grooves in the Spindle Pulley
(#99) and Motor Pulley (#105 [Fig. 7]).
c.
Ease the Motor back to its original position to tighten the tension on
the V-Belt (see Install the V-Belt).
d.
Retighten the Bolt to secure the Motor in place.
MATERIAL
Tool Steel, Stainless Alloy Steels,
Bearing Bronze
Medium to High Carbon Steels,
Hard Brass or Bronze
Low to Medium Carbon Steels,
Soft Brass, Aluminum, Plastic
ADJUSTING THE BAND SAW
QUICK VISE ADJUSTMENT FOR AN ANGLE CUT
1.
Loosen the Bolt (#43) and adjust the Mitre
Vise Plate (16-3) to the desired angle as
indicated by the Angle Scale (Fig. 16-1).
Retighten the Bolt.
2.
Loosen the Bolt (#40) and adjust the
Moveable Vise Plate (Fig. 16-2) to parallel the
Mitre Vise Plate (Fig. 16-3). Retighten
the Bolt.
ADJUST THE STOCK STOP
1.
Loosen the Socket Head Screw (#17) that holds
the Stock Stop (#18) to the Shaft (#19).
2.
Adjust the Stock Stop to the desired length
position. Retighten the Socket Head Screw.
Visit www.princessauto.com for more information
4 x 6 in. Metal Cutting Band Saw
SPEED (FPM)
80
120
200
PULLEY GROOVE
Spindle
16-1
16-2
9113465
Motor
Table 1
16-3
Fig. 16
Fig. 17
17
Publicité
