Publicité
Les langues disponibles
Les langues disponibles
9113465
2.
Align the mounting hole in the Pulley
Cover with the mounting hole in the
Body Frame (#93).
3.
Secure the Pulley Cover to the Band Saw,
using one Screw (#89), Spring
Washer (#7) and Flat Washer (#8).
SPINDLE PULLEY AND
MOTOR PULLEY
1.
Slide the Spindle Pulley (#99) fully onto the Spindle Shaft (#97). Secure the
Spindle Pulley to the Spindle Shaft using
one Screw (#52).
2.
Insert the Shaft Key (#51) in the slot on the
Motor Shaft. Align the slot in the Motor Pulley
(#105) with the Shaft Key. Slide the Motor
Pulley fully onto the Motor Shaft. Secure the
Motor Pulley to the Motor Shaft using one
Screw (#52).
INSTALL THE V-BELT
1.
Loosen the Bolt (#108) and press the Motor
(#115) toward the Body (Fig. 8).
2.
Place the V-Belt (#100) around the top
grooves in the Spindle Pulley (#99) and
Motor Pulley (#105 [Fig. 7]).
3.
Adjust the Motor' s position until the
V-Belt' s tension will only allow you to push
it in 1/2 an inch with your thumb at the
midpoint between the pulleys.
4.
Retighten the Bolt to secure the Motor
in place.
IMPORTANT! Always securely close the Lid on the Pulley Cover after installing a
V-Belt or adjusting the cutting speed.
14
4 x 6 in. Metal Cutting Band Saw
For technical questions call 1-800-665-8685
V1.0
6-1
Fig. 6
Fig. 7
Fig. 8
Publicité
