Publicité
Les langues disponibles
Les langues disponibles
9113465
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key. Dashed
numbers in parenthesis (Fig. 1-1) refer to a specific point in an illustration or image.
ASSEMBLE THE STAND
1.
Insert the Pull Handle (#12) into the two mounting holes located in the
upper section of one Stand (#10). Then secure the Pull Handle to the Stand,
using two Pins (#11).
2.
Attach one end of the Tool Plate (#128) to the upper section of one
Stand (#10), using two Bolts (#9), four Flat Washers (#8), and two
Nuts (#6).
3.
Attach the other end of the Tool Plate to the upper section of the
remaining Stand, using two Bolts (#9), four Flat Washers (#8), and two
Nuts (#6).
4.
Align the two mounting holes in the Wheel Bracket (#130) with the two
mounting holes located in the lower section of the Stand without the
Pull Handle.
5.
Secure the Wheel Bracket to the Stand, using two Bolts (#9), four Flat
Washers (#8), and two Nuts (#6).
12
4 x 6 in. Metal Cutting Band Saw
For technical questions call 1-800-665-8685
V1.0
Fig. 2
Publicité
