JVC GR-AXM1U Manuel D'instructions page 35

EDITING
Editing cable
(optional 3.5 ø
mini-plug cable)
Downloaded from: https://www.usersmanualguide.com/
PLAY/PAUSE
EDIT
Power switch
To EDIT To AUDIO out
To VIDEO out
Audio and Video
cable (optional)
To Remote To AUDIO IN
PAUSE To VIDEO IN
VCR (Recording deck)
Tape Dubbing
CONNECT EQUIPMENT
1
Following the illustration on the left, connect the
camcorder and the VCR. If you have a Remote
PAUSE terminal, use the editing cable to connect it
to the camcorder and the VCR. (See "NOTES" below
for details.)
PREPARE FOR DUBBING
2
Set the camcorder's power switch to PLAY, turn on
the VCR's power, and insert the appropriate
cassettes in the camcorder and the VCR.
SELECT VCR MODE
3
Engage the VCR's AUX and Record-Pause modes.
FIND EDIT-IN POINT
4
Engage the camcorder's Play mode to find a spot
just before the edit-in point. Once it's reached, press
PAUSE on the camcorder.
START EDITING
5
Press PLAY on the camcorder and engage the VCR's
Record mode.
STOP EDITING TEMPORARILY
6
Engage the VCR's Record-Pause mode and press
PAUSE on the camcorder.
EDIT MORE SEGMENTS
7
Repeat steps 4 through 6 for additional editing, then
stop the VCR and camcorder when finished.
NOTES:
● When using a Remote PAUSE terminal, pressing EDIT
on the camcorder in step 5 automatically engages the
VCR's Record mode.
● When using a Remote PAUSE terminal, you can access
a function called Master Edit Control System. Before
beginning, reset the camcorder's counter to
"M0:00:00" at an edit-out point. When the tape
reaches this point (remember there's a small margin of
error) during editing, the camcorder and VCR pause
automatically. However, some VCRs are not compat-
ible with the Master Edit Control System.
35