Before First Use - Zanussi ZDI 16011 Notice D'utilisation

Before first use

1. Make sure that the set level of the water softener
agrees with the water hardness in your area. If not,
adjust the water softener. Contact your local water au-
thority to know the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appliance. Start a
programme to remove them. Do not use detergent
and do not load the baskets.
If you use the combi detergent tablets, activate the
multitab function. These tablets contain detergent,
rinse aid and other added agents. Be sure that these tab-
German
degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
www.zanussi.com
Water hardness
French mmol/l
degrees
(°fH)
91 - 125 9.1 - 12.5
76 - 90 7.6 - 9.0
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
lets are applicable to the water hardness in your area. Re-
fer to the instructions on the packaging of the products.
Adjusting the water softener
Hard water contains a high quantity of minerals that can
cause damage to the appliance and bad washing results.
The water softener neutralises these minerals.
The dishwasher salt keeps the water softener clean and in
good conditions. Refer to the table to adjust the water
softener to the right level. It makes sure that the water
softener uses the correct quantity of dishwasher salt and
water.
You must adjust the water softener manually and
electronically.
Clarke
degrees
64 - 88
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
Water softener
adjustment
Manual Electronic
10
1)
2
9
1)
2
8
1)
2
7
1)
2
6
1)
2
1) 1)
2 5
1 4
1 3
1 2
2) 2)
1 1
19